Set the bath, regardless of its execution, whether cast iron or acrylic, often does not require special skills and too much effort. If, in order to install a bath of cast iron without any help you can not do, the installation of acrylic baths afford to almost everyone. It is important to only take a responsible approach to this process. In this article, you will learn how to properly install acrylic bathtub. But first, let me give a little advice: do not buy cheap imitations, since the installation and use of a bathroom will give you a lot of problems. Preliminary work.
The first step is to prepare the room where the bathtub will be installed. All plumbing findings should be placed in an accessible place, to ensure unhindered access to them. The siphon is located at a distance of 12-16 cm from the floor. Before installing, it fits on the tub side, and made installation of a siphon with the release and overflow. During the installation of acrylic bath should be as close as possible to the wall. It is also recommended that it was a slight bias toward release.
Joint sewer pipe (Which is inserted into the outlet) and siphon zavaltsovyvaetsya. Installing a bath. Immediately install acrylic bath itself begins with pouring the cement pad on which, in fact, will draw a bath. Bath mounted on a special frame made in the factory or on their own. Further, this frame is hidden beneath decorative panels or tiles. If you decide to make a frame on their own, remember that it must have high durability and reliability. As practice shows, is much easier installation process, when the surface of the frame is lined with tiles. If the tiles are not laid, the acrylic bath should be lifted above the surface of the frame, tucked under bath rim installation, the appropriate thickness of the tile and mastic adhesive layer. As the pads, you can use the material at hand: cutting boards, pieces of plywood and pr.Kogda all pads are evenly distributed around the bath, carefully (so as not to break the established drain-corrugation and other services!) tilt the tub to the side of the wall and attach the long leg. Then also gently lower it and raise the nearest edge to deliver the remaining legs. While the cement foundation has not had time to dry bath in the lower opening frame. Adjustment mechanisms that are provided with legs retention of most current models of acrylic bathtubs, makes it easy to center the bath. Under the protruding corners better than anything put under that bath not prosela.Esli you are installing an acrylic tub with Jacuzzi it's time to connect the equipment (motor with a pump spray, a control system, etc.). Such activities require compliance with all security measures, so the mains voltage must be disabled until completion of all work on installing the tub. After completion of installation work, fill the bathtub with water to determine the tightness of all plumbing connections. You can use the bathroom after a full drying cement osnovaniya.Scheli that arose during the installation of bath tubs between board and wall repaired with silicone sealant. Larger gaps can be closed using the failed foundation of brick or assembly foam. The final step is installing the decorative panel.